Command Line Reference Guide

Usage
Information
Use the fcoe-map command to bind an FC port to an FC-FCOE fabric.
When a Fibre Channel port operates in N mode, the principal switch in the fabric provides the
FCoE Forwarder (FCF) attributes, such as MAC address, FIP priority, and FIP keepalive timeout.
To removed the configured FCoE map, enter the no fabric command.
Example
FTOS(conf)#interface fibrechannel 0/11
FTOS(conf-if-fc-0/11)#fabric SAN_FABRIC_A
Related
Commands
interface fibrechannel — configures a Fibre Channel interface on the switch.
show interfaces fibrechannel — displays the configuration of a Fibre Channel interface.
feature fc
Enable Fibre Channel capability on the S5000.
S5000
Syntax
feature fc
Defaults The S5000 is not enabled to operate in Fibre Channel mode.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use this command to configure the S5000 to interoperate with Fibre Channel devices in SAN
fabrics.
Enter the no feature fc command to disable the Fibre Channel command-line interface
and free memory resources allocated to Fibre Channel operation.
Example
FTOS(conf)#feature fc
Related
Commands
show interfaces fibrechannel — displays the configuration of a Fibre Channel interface.
interface fibrechannel
Configure a Fibre Channel (FC) interface on the switch.
S5000
Syntax
interface fibrechannel slot/port
549