Command Line Reference Guide
• The existing show interface command has been modified to display the configured broadcast address.
debug ip udp-helper
Enable UDP debug and display the debug information on a console.
S5000
Syntax
debug ip udp-helper
To disable debug information, use the no debug ip udp-helper command.
Defaults Debug disabled.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS#debug ip udp-helper
UDP helper debugging is on
01:20:22: Pkt rcvd on Te 5/0 with IP DA (0xffffffff) will be
sent on Te 5/1 Te 5/2
Vlan 3
01:44:54: Pkt rcvd on Te 7/0 is handed over for DHCP
processing.
Related
Commands
ip udp-broadcast-address – configures a UDP IP address for broadcast.
ip udp-helper udp-port – enables the UDP broadcast feature on an interface.
show ip udp-helper – displays the configured UDP helper(s) on all interfaces.
ip udp-broadcast-address
Configure an IP UDP address for broadcast.
S5000
Syntax
ip udp-broadcast-address address
To delete the configuration, use the no ip udp-broadcast-address address
command.
Parameters
address
Enter an IP broadcast address in dotted decimal format (A.B.C.D).
544