Command Line Reference Guide
show port-channel-flow
Display an egress port in a given port-channel flow.
S5000
Syntax
show port-channel-flow outgoing-port-channel number incoming-
interface interface {source-ip address destination-ip address}
| {source-port number destination-port number} | {source-mac
address destination-mac address}
Parameters
outgoing-port-
channel
number
Enter the keywords outgoing-port-channel followed by the
number of the port channel to display flow information.
For a Port Channel interface, enter the keywords port-channel
followed by a number. The range is 1 to 128.
incoming-
interface
interface
Enter the keywords incoming-interface followed by the
interface type and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
source-ip
address
Enter the keywords source-ip followed by the IP source address
in IP address format.
destination-ip
address
Enter the keywords destination-ip followed by the IP
destination address in IP address format.
source-port
number
Enter the keywords source-port followed by the source port
number. The range is 1 to 65536. The default is None.
destination-port
number
Enter the keywords destination-port followed by the
destination port number. The range is 1 to 65536. The default is None.
source-mac
address
Enter the keywords source-mac followed by the MAC source
address in the nn:nn:nn:nn:nn:nn format.
destination-mac
address
Enter the keywords destination-mac followed by the MAC
destination address in the nn:nn:nn:nn:nn:nn format.
Command Modes EXEC
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Because this command calculates based on a Layer 2 hash algorithm, use this command to
display flows for switched Layer 2 packets, not for routed packets (use the show ip flow
command to display routed packets).
542