Command Line Reference Guide

Input 01.50Mbits/sec, 2433 packets/sec
Output 00.02Mbits/sec,4 packets/sec
Time since last interface status change: 00:22:34
FTOS#
Usage
Information
The following describes the show interfaces port-channel brief command
shown in the Example below.
Field Description
LAG Lists the port channel number.
Mode Lists the mode:
L3 - for Layer 3
L2 - for Layer 2
Status Displays the status of the port channel.
down - if the port channel is disabled (shutdown)
up - if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled) Displays the status of the physical interfaces (up or down).
In Layer 2 port channels, an * (asterisk) indicates which
interface is the primary port of the port channel. The primary
port sends out interface PDU.
In Layer 3 port channels, the primary port is not indicated.
Example
FTOS#sh int por 1 br
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Te 3/0 (Up) *
Te 3/1 (Down)
Te 3/2 (Up)
FTOS#
Related
Commands
show lacp – displays the LACP matrix.
541