Command Line Reference Guide

Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS(conf-if-po-1)#show config
!
interface Port-channel 1
no ip address
shutdown
FTOS(conf-if-po-1)#
show interfaces port-channel
Display information on configured Port Channel groups.
S5000
Syntax
show interfaces port-channel [channel-number] [brief]
Parameters
port-channel
channel-number
Enter the keyword port-channel followed by a number. The
range is 1 to 128.
brief (OPTIONAL) Enter the keyword brief to display only the port
channel number, the state of the port channel, and the number of
interfaces in the port channel.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes the show interfaces port-channel command shown in the
Example below.
Field Description
Port-Channel 1... Displays the LAG’s status. In the Example, the status of the LAG’s LAG
fate-sharing group (“Failover-group”) is listed.
Hardware is... Displays the interface’s hardware information and its assigned MAC
address.
Port-channel is
part...
Indicates whether the LAG is part of a LAG fate-sharing group
(“Failover-group”).
Internet
address...
States whether an IP address is assigned to the interface. If an IP
address is assigned, that address is displayed.
MTU 1554... Displays link and IP MTU.
539