Command Line Reference Guide

shutdown – disables/enables the port channel.
group
Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).
S5000
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number command.
Parameters
group_number
Enter an integer from 1 to 32 that uniquely identifies this LAG fate-
sharing group.
port-channel
number
Enter the keywords port-channel followed by an existing LAG
number. Enter this keyword/variable combination twice, identifying
the two LAGs to be paired.
Defaults none
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
port-channel failover-group – accesses PORT-CHANNEL FAILOVER-GROUP mode to configure
a LAG failover group.
show interfaces port-channel – displays information on configured Port Channel groups.
interface port-channel
Create a Port Channel interface, which is a link aggregation group (LAG) containing up to 16 physical interfaces on the
S5000 switch.
S5000
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-number
command.
Parameters
channel-number
For a Port Channel interface, enter the keywords port-channel
followed by a number. The range is 1 to 128.
536