Command Line Reference Guide

individual interfaces within the port channel. To enable a port channel, you must enter no
shutdown on the port channel interface and at least one interface within that port channel.
The shutdown and description commands are the only commands that you can
configure on an interface that is a member of a port channel.
Related
Commands
interface port-channel – creates a port channel interface.
interface vlan – creates a VLAN.
show ip interface – displays the interface routing status. Add the keyword brief to display a
table of interfaces and their status.
speed (Management interface)
Set the speed for a Management interface.
S5000
Syntax
speed {10 | 100 | 10000 | auto}
To return to the default setting, use the no speed {10 | 100} command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 10/100 Mb/s.
10000 Enter the keyword 10000 to set the interface’s speed to 1000 Mb/s (1
Gb/s).
auto Enter the keyword auto to set the interface to auto-negotiate its
speed.
Defaults auto
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command is supported only on a Management interface.
Related
Commands
interface ManagementEthernet – configures the Management port on the system (either the
primary or standby stack-unit).
duplex (10/100 Interfaces) – configures duplex mode on physical interfaces with the speed set
to 10/100.
management route – configures a static route that points to the Management interface or a
forwarding router.
532