Command Line Reference Guide

2 64-byte pkts, 29705 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
pkts
29707 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 3d22h19m
TenGigabitEthernet 0/1 is down, line protocol is down
Hardware is DellForce10Eth, address is 5c:f9:dd:ee:ff:c2
Current address is 5c:f9:dd:ee:ff:c2
Pluggable media present, SFP+ type is 10GBASE-SR
Medium is MultiRate, Wavelength is 850nm
No power
Interface index is 33883144
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 2d23h41m
!-----------------output truncated ----------------!
Related
Commands
show hardware stack-unit – displays data plane and management plane input/output statistics.
show interfaces – displays information on a specific physical interface or virtual interface.
show interfaces status
Display a summary of interface information or specify a stack-unit and interface to display status information on that
specific interface only.
S5000
Syntax
show interfaces [type slot/port] status
Parameters
interfaces type
slot/port
(OPTIONAL) Enter the interfaces keyword followed by the
interface type and slot/port or number information, then enter the
status keyword.. Valid slot numbers are 0-11. The valid port
numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a range of interfaces, enter the keyword range followed
by slot/port number.
522