Command Line Reference Guide

ManagementEthernet 8/0 NO up not present
ManagementEthernet 9/0 NO up not present
ManagementEthernet 10/0 NO up not present
ManagementEthernet 11/0 NO up not present
Vlan 1 NO admin down down
Vlan 100 NO admin down down
FTOS#
Related
Commands
show interfaces – displays information on a specific physical interface or virtual interface.
show interfaces stack-unit
Display information on all interfaces on a specific S5000 stack member.
S5000
Syntax
show interfaces stack-unit unit-number
Parameters
stack-unit unit-
number
Enter the keyword stack-unit followed by the unit number. The
range is 0 to 11.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS#sh int stack-unit 0
TenGigabitEthernet 0/0 is up, line protocol is up
Hardware is DellEth, address is 5c:f9:dd:ee:ff:c2
Current address is 5c:f9:dd:ee:ff:c2
Pluggable media present, SFP+ type is 10GBASE-SR
Medium is MultiRate, Wavelength is 850nm
SFP+ receive power reading is -2.4018dBm
Interface index is 33883144
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 3d22h23m
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
29704 packets, 3333165 bytes, 0 underruns
521