Command Line Reference Guide

Output 0 errors, 0 invalid protocol
Time since last interface status change: 3d21h47m
Related
Commands
show interfaces configured – displays any interface with a non-default configuration.
show interfaces stack-unit – displays information on all interfaces on a specific stack-unit.
show interfaces rate – displays information of either rate limiting or rate policing on the
interface.
show interfaces switchport – displays Layer 2 information about the interfaces.
show inventory – displays the switch type, components (including media), FTOS version
including hardware identification numbers, and configured protocols.
show ip interface – displays Layer 3 information about the interfaces.
show stack-unit – displays the status of the stack-unit(s).
show range – displays all interfaces configured using the interface range command.
show interfaces configured
Display any interface with a non-default configuration.
S5000
Syntax
show interfaces configured
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS#show interfaces configured
TenGigabitEthernet 0/10 is up, line protocol is up
Hardware is DellEth, address is 5c:f9:dd:ee:ff:c2
Current address is 5c:f9:dd:ee:ff:c2
Pluggable media present, SFP+ type is 10GBASE-SR
Medium is MultiRate, Wavelength is 850nm
SFP+ receive power reading is -3.1158dBm
Interface index is 36242440
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 2d23h34m
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
517