Command Line Reference Guide

Usage
Information
The output of the show interfaces command displays the configured rate interval, along
with the collected traffic data.
Related
Commands
show interfaces – displays information on physical and virtual interfaces.
show config
Display the interface configuration.
S5000
Syntax
show config
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS(conf-if)#show conf
!
interface TenGigabitEthernet 0/0
ip address 10.1.1.1/16
portmode hybrid
switchport
dcb-policy input pfc3
no shutdown
FTOS(conf-if)#
show config (from INTERFACE RANGE mode)
Display the bulk configured interfaces (interface range).
S5000
Syntax
show config
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS(conf-if-range-te-0/1)#interface range tengig 0/1 - 2
FTOS(conf-if-range-te-0/1-2)#show config
!
interface TenGigabitEthernet 0/1
no ip address
portmode hybrid
switchport
dcb-policy input pfc3
512