Command Line Reference Guide

• Bulk configuration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk configuration with a warning
message.
• The interface range prompt includes interface types with slot/port information
for valid interfaces. The prompt allows for a maximum of 32 characters. If the bulk
configuration exceeds 32 characters, it is represented by an ellipsis ( ... ).
• When the interface range prompt has multiple port ranges, the smaller port
range is excluded from the prompt.
• If overlapping port ranges are specified, the port range is extended to the smallest
start port and the biggest end port.
Example (Bulk)
FTOS(conf)#interface range fc 0/0 - 5 , te 1/12 - 23 , te 3/36
- 47
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example (Multiple
Ports)
FTOS(conf)#interface range te 1/12 - 23 , te 2/24 - 30
FTOS(conf-if-range-te-1/12-23,te-2/24-30)#
Example
(Overlapping
Ports)
FTOS(conf)#interface range te 2/12 - 16 , te 2/12 - 23
FTOS(conf-if-range-te-2/12-23)#
Usage
Information
Only VLAN and port-channel interfaces created using the interface vlan and
interface port-channel commands can be used in the interface range
command.
Use the show running-config command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the show running-
config
command can not be used with the bulk configuration feature of the interface
range command. You cannot create virtual interfaces (VLAN, Port-channel) using the
interface range command.
NOTE: If a range has VLAN, physical, and port-channel, interfaces, only commands related
to physical interfaces can be bulk configured. To configure commands specific to VLANs
or port-channels, only those respective interfaces should be configured in a particular
range.
Example (Single
Range)
This example shows a single range bulk configuration.
FTOS(config)# interface range tengigabitethernet 3/36 - 47
FTOS(config-if-range-te-3/36-47)# no shutdown
FTOS(config-if-range)#
Example (Multiple
Range)
This example shows how to use commas to add different interface types to the range enabling
all Ten Gigabit Ethernet interfaces in the range 0/0 to 0/11 and two Forty Gigabit Ethernet
interfaces 48 and 52.
FTOS(config-if)# interface range gigabitethernet 0/0 - 11 ,
fortygigabitethernet 48 - 52
FTOS(config-if-range-te-0/0-11,fo-48-52)# no shutdown
FTOS(config-if-range)#
502