Command Line Reference Guide
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a range of interfaces, enter the keyword range followed
by slot/port number.
• For a Fibre Channel interface, enter the keyword
FibreChannel followed by slot/port numbers. The port
range is 0 to 47.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
• For a Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To place an
interface in Layer 2 mode, ensure that the interface’s configuration does not contain an IP
address and enter the switchport command.
Example
FTOS(conf)#interface te 0/0
FTOS(conf-if-te-0/0)#
Related
Commands
interface fibrechannel — configures a Fibre Channel interface.
interface loopback – configures a Loopback interface.
interface null – configures a Null interface.
interface port-channel – configures a port channel.
interface vlan – configures a VLAN.
show interfaces – displays the interface configuration.
498