Command Line Reference Guide

ecmp-group
Provides a mechanism to monitor traffic distribution on a link aggregation group (LAG) bundle. A system log or simple
network management protocol (SNMP) trap is generated when the standard deviation of traffic distribution on a member
link exceeds a defined threshold.
S5000
Syntax
ecmp-group {ecmp-path} [interface interface] [monitoring
enable]
To negate a command, use the no command.
Parameters
ecmp-path Enter the path number for the LAG. The range is 2 to 64.
interface Enter the following keywords and slot/port to add the interface to the
LAG:
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
monitoring Enter the keyword monitoring to monitor the LAG. To enable
monitoring, follow by entering the keyword
enable.
Defaults Off
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
flowcontrol
Set how the system responds to and generates 802.3x pause frames on Ethernet interfaces.
S5000
Syntax
flowcontrol rx {off | on} tx {off | on}
Parameters
rx on Enter the keywords rx on to process the received flow control
frames on this port. This is the default value for the receive side.
rx off Enter the keywords rx off to ignore the received flow control
frames on this port.
495