Command Line Reference Guide

Defaults Without an interface specified, the command clears all interface dampening counters.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
After you enter the clear counters command and verify the results with the show
interfaces command, the line rate is not reset to 0.00%.
Example
FTOS#clear dampening tengigabitethernet 1/2
Clear dampening counters on Te 1/2 [confirm] y
FTOS#
Related
Commands
show interfaces dampening – displays interface dampening information.
dampening – configures dampening on an interface.
cx4-cable-length
Configure the length of the cable to be connected to the selected CX4 port.
S5000
Syntax
[no] cx4-cable-length {long | medium | short}
Parameters
long | medium |
short
Enter the keyword that matches the cable length to be used at the
selected port:
• short = For 1-meter and 3-meter cable lengths.
• medium = For 5-meter cable length.
• long = For 10-meter and 15-meter cable lengths.
Defaults medium
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command only works on ports that the system recognizes as CX4 ports. The show
interfaces
command shown in the Example below describes an attempt to configure an
XFP port in an S25P with the command after inserting a CX4 converter into the port.
NOTE: When using a long CX4 cable, to avoid errors, configure the cable using the cx4-
cable-length short command only.
NOTE: The 15M CX4 active cable is not supported on the S5000.
NOTE: For information about using XFP ports with CX4 cables, refer to your S5000
hardware guide.
491