Command Line Reference Guide
extcommunity-list Add a Extended community list
entry
ftp FTP configuration commands
helper-address DHCP relay agent configuration
host Add an entry to the ip
hostname table
igmp Internet Group Management
Protocol
max-frag-count Max. fragmented packets
allowed in IP re-assembly
mroute Multicast routes and counters
msdp Multicast source discovery
protocol
multicast-limit Max entries in Multicast TIB
multicast-msdp Enable IP multicast MSDP
protocol
multicast-routing Enable IP multicast forwarding
name-server Specify addess of name server
to use
pim Protocol Independent Multicast
prefix-list Build a prefix list
radius Interface configuration for
RADIUS
route Establish static routes
scp SCP configuration commands
source-route Process packets with source
routing header options
ssh SSH configuration commands
tacacs Interface configuration for
TACACS+
telnet Specify telnet options
tftp TFTP configuration commands
FTOS(conf)#
When entering commands, you can take advantage of the following timesaving features:
• The commands are not case-sensitive.
• You can enter partial (truncated) command keywords. For example, you can enter int te followed by slot/port
information for the
interface tengigabitethernet command.
• Use the TAB key to complete keywords in commands.
• Use the up Arrow key to display the last enabled command.
• Use either the Backspace key or Delete key to erase the previous character.
• Use the left and right Arrow keys to navigate left or right in the FTOS command line.
The shortcut key combinations at the FTOS command line are as follows:
Key Combination Action
CNTL-A Moves the cursor to the beginning of the command line.
CNTL-B Moves the cursor back one character.
CNTL-D Deletes the character at the cursor.
CNTL-E Moves the cursor to the end of the line.
CNTL-F Moves the cursor forward one character.
CNTL-I Completes a keyword.
49