Command Line Reference Guide

Interfaces

The commands in this chapter are supported in FTOS on the S5000 switch.

This chapter contains the following sections:

• Basic Interface Commands

• Port Channel Commands

• Time Domain Reflectometer (TDR)

• UDP Broadcast

Basic Interface Commands

The following commands are for Physical, Loopback, and Null interfaces.

clear counters

Clear the counters used in the show interfaces commands for all virtual router redundancy protocol (VRRP) groups,

virtual local area networks (VLANs), and physical interfaces, or selected ones.

S5000

Syntax

clear counters [interface-type slot/port] [vrrp [{[ipv6]

vrid }] | learning-limit]

Parameters

interface-type

slot/port

(OPTIONAL) Enter the interface type followed by slot/port or number

information. Valid slot numbers are 0-11. The valid port numbers for

each interface type are listed below.

• For a 10-Gigabit Ethernet interface, enter the keyword

tengigabitethernet followed by slot/port numbers.

The port range is 0 to 63.

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE followed by slot/port numbers. The ports are 48,

52, 56, and 60.

• For a Loopback interface, enter the keyword loopback

followed by a number from 0 to 16383.

• For a Management interface, enter the keyword

managementethernet followed by slot/port numbers.

The port is 0.

489