Command Line Reference Guide

Example (VLT)
NOTE: The asterisk (*) after the port channel number (Po 2) highlighted in the Example
below indicates the port channel is VLT, that the local VLT port channel is down and the
remote VLT port is up.
FTOS#show ip igmp groups
Total Number of Groups: 5
IGMP Connected Group Membership
Group Address Interface Mode Uptime Expires Last Reporter
225.0.0.0 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Member Ports: Po 2*
225.0.0.1 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Member Ports: Po 2*
225.0.0.2 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Member Ports: Po 2*
225.0.0.3 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Member Ports: Po 2*
225.0.0.4 Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Member Ports: Po 2*
show ip igmp interface
View information on the interfaces participating in IGMP.
S5000
Syntax
show ip igmp interface [type slot/port]
Parameters
interface
type
slot/port
(OPTIONAL) Enter the interface keyword followed by the
interface type and slot/port or number information. Valid slot numbers
are 0-11. The valid port numbers for each interface type are listed
below.
For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
Command Modes
EXEC
EXEC Privilege
482