Command Line Reference Guide
Command History
Version 9.0(1.3) Introduced on the S5000.
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
S5000
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time command.
Parameters
seconds
Enter the number of seconds for the maximum response time. The
range is 1 to 25. The default is 10 seconds.
Defaults 10 seconds
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
ip igmp ssm-map
Use a statically configured list to translate (*,G) memberships to (S,G) memberships.
S5000
Syntax
ip igmp ssm-map std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them with (*,G)
state, use the ip igmp ssm-map std-access-list source-address command.
Parameters
std-access-list
Specify the standard IP access list that contains the mapping rules
for multicast groups.
source-address
Specify the multicast source address to which the groups are
mapped.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
478