Command Line Reference Guide

Defaults Disabled.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
IGMP commands accept only non-VLAN interfaces—specifying VLAN does not yield results.
This command displays packets for IGMP and IGMP snooping.
ip igmp access-group
Use this feature to specify access control for packets.
S5000
Syntax
ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list command.
Parameters
access-list Enter the name of the extended ACL (16 characters maximum).
Defaults Not configured
Command Modes INTERFACE (conf-if- interface-slot/port )
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The access list accepted is an extended ACL. Use this feature to block IGMP reports from
hosts, on a per-interface basis based on the group address and source address that you
specify in the access list.
ip igmp group-join-limit
Use this feature to limit the number of IGMP groups that can be joined in a second.
S5000
Syntax
ip igmp group-join-limit number
Parameters
number Enter the number of IGMP groups permitted to join in a second. The
range is 1 to 10000.
Defaults none
Command Modes CONFIGURATION (conf-if- interface-slot/port )
475