Command Line Reference Guide

gvrp enable
Enable GVRP on physical interfaces and LAGs.
S5000
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults Disabled.
Command Modes CONFIGURATION-INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
disable – globally disables GVRP.
gvrp registration
Configure the GVRP register type.
S5000
Syntax
gvrp registration {fixed | normal | forbidden}
To return to the default, use the gvrp register normal command.
Parameters
fixed Enter the keyword fixed followed by the VLAN range in a comma
separated VLAN ID set.
normal Enter the keyword normal followed by the VLAN range in a comma
separated VLAN ID set. This is the default.
forbidden Enter the keyword forbidden followed by the VLAN range in a
comma separated VLAN ID set.
Defaults normal
Command Modes CONFIGURATION-INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Fixed registration prevents an interface, configured using the command line, to belong to a
VLAN (static configuration) from being unconfigured when it receives a Leave message.
Therefore, Registration mode on that interface is fixed.
Normal registration is the default registration. The port’s membership in the VLAN depends on
GVRP. The interface becomes a member of a VLAN after learning about the VLAN through
461