Command Line Reference Guide
Parameters
config Enter the keyword config to enable debugging on the GVRP
configuration.
event Enter the keyword event to enable debugging on the JOIN/LEAVE
events.
pdu Enter the keyword pdu followed by the interface type and slot/port or
number information. Valid slot numbers are 0-11. The valid port
numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
Defaults Disabled.
Command Modes EXEC
Command History
Version 9.0(1.3) Introduced on the S5000.
disable
Globally disable GVRP.
S5000
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults Enabled.
Command Modes CONFIGURATION-GVRP
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
gvrp enable – enables GVRP on physical interfaces and LAGs.
protocol gvrp – access GVRP protocol.
459