Command Line Reference Guide

protocol frrp
Enter the Resilient Ring Protocol and designate a ring identification.
S5000
Syntax
protocol frrp {ring-id}
To exit the ring protocol, use the no protocol frrp {ring-id} command.
Parameters
ring-id
Enter the ring identification number. Range: 1 to 255.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command places you into the resilient ring protocol. After executing this command, the
command line prompt changes to conf-frrp.
show frrp
Display the Resilient Ring Protocol configuration.
S5000
Syntax
show frrp [ring-id [summary]] | [summary]
Parameters
ring-id
Enter the ring identification number. The range is 1 to 255
summary (OPTIONAL) Enter the keyword summary to view just a summarized
version of the Ring configuration.
Defaults none
Command Modes EXEC
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Executing this command without the optional ring-id command clears the statistics
counters on all the available rings. FTOS requires a command line confirmation before the
command executes. This commands clears the following counters:
hello Rx and Tx counters
Topology change Rx and Tx counters
The number of state change counters
454