Command Line Reference Guide

member-vlan
Specify the member VLAN identification numbers.
S5000
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters
vlan-range
Enter the member VLANs using VLAN IDs (separated by commas), a
range of VLAN IDs (separated by a hyphen), a single VLAN ID, or a
combination. For example: VLAN IDs (comma-separated): 3, 4, 6.
Range (hyphen-separated): 5-10. Combination: 3, 4, 5-10, 8.
Defaults none
Command Modes CONFIGURATION (conf-frrp)
Command History
Version 9.0(1.3) Introduced on the S5000.
mode
Set the Master or Transit mode of the ring.
S5000
Syntax
mode {master | transit}
To reset the mode, use the no mode {master | transit} command.
Parameters
master Enter the keyword master to set the Ring node to Master mode.
transit Enter the keywordtransit to set the Ring node to Transit mode.
Defaults Mode None
Command Modes CONFIGURATION (conf-frrp)
Command History
Version 9.0(1.3) Introduced on the S5000.
453