Command Line Reference Guide

number of sessions are active with an ENode, additional sessions are not allowed as long as
the total number is greater than the newly configured limit.
When the maximum number of FIP snooping sessions for an ENode are already active on the
switch, a log message is recorded if the ENode tries to log in to initiate another session.
fip-snooping port-mode fcf
Configure the port for bridge-to-FCF links.
S5000
Syntax
fip-snooping port-mode fcf
To disable the bridge-to-FCF link on a port, use the no fip-snooping port-mode fcf
command.
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
NOTE: The FCoE-Trusted Port mode used to connect to another FIP snooping bridge
(bridge-bridge link) is not supported on the S5000.
show fip-snooping config
Display the FIP snooping status and configured FC-MAP values.
S5000
Syntax
show fip-snooping config
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS# show fip-snooping config
FIP Snooping Feature enabled Status: Enabled
FIP Snooping Global enabled Status: Enabled
Global FC-MAP Value: 0X0EFC00
FIP Snooping enabled VLANs
VLAN Enabled FC-MAP
443