Command Line Reference Guide

0 13% ETS
1 13% ETS
2 13% ETS
3 13% ETS
4 12% ETS
5 12% ETS
6 12% ETS
7 12% ETS
Oper status is init
Conf TLV Tx Status is disabled
ETS DCBx Oper status is Down
Reason: Port shutdown
State Machine Type is Feature
0 Input Conf TLV Pkts, 0 Output Conf TLV Pkts, 0 Error Conf
TLV Pkts
show interfaces pfc
Displays the PFC configuration applied to ingress traffic on an Ethernet interface, including priorities and link delay.
S5000
Syntax
show interfaces type slot/port pfc {summary | detail}
Parameters
type slot/ port pfc Enter the Ethernet interface type and slot/port or number information
followed by the keyword pfc. Valid slot numbers are 0-11. The valid
port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
{summary | detail} Enter the keyword summary for a summary list of results or enter the
keyword detail for a full list of results.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To clear the PFC TLV counters, use the clear pfc counters interface port-
type slot/port command.
The following table describes the show interface pfc {summary} command output
shown in the Example below.
410