Command Line Reference Guide
Local DCBx Compatibility mode is CEE
Local DCBx Configured mode is CEE
Peer Operating version is CEE
Local DCBx TLVs Transmitted: ErPfi
Local DCBx Status
-----------------
DCBx Operational Version is 0
DCBx Max Version Supported is 0
Sequence Number: 2
Acknowledgment Number: 2
Protocol State: In-Sync
Peer DCBx Status:
----------------
DCBx Operational Version is 0
DCBx Max Version Supported is 255
Sequence Number: 2
Acknowledgment Number: 2
2 Input PFC TLV pkts,3 Output PFC TLV pkts,0 Error PFC pkts,
0 PFC Pause Tx pkts 0 Pause Rx pkts
2 Input PG TLV Pkts, 3 Output PG TLV Pkts, 0 Error PG TLV
Pkts
2 Input Appln Priority TLV pkts, 0 Output Appln Priority TLV
pkts,
0 Error Appln Priority TLV Pkts
Total DCBx Frames transmitted 27
Total DCBx Frames received 6
Total DCBx Frame errors 0
Total DCBx Frames unrecognized 0
show interfaces ets
Displays the ETS configuration applied to egress traffic on an Ethernet interface, including priority groups with priorities
and bandwidth allocation.
S5000
Syntax
show interfaces type slot/port ets {summary | detail}
Parameters
type slot/port
ets Enter the Ethernet interface type and slot/port or number information
followed by the keyword ets. Valid slot numbers are 0-11. The valid
port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
{summary | detail} Enter the keyword summary for a summary list of results or enter the
keyword detail for a full list of results.
406