Command Line Reference Guide
Example
FTOS# show dcb
DCB Status : Enabled
FTOS#
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
S5000
Syntax
show qos dcb-map map-name
Parameters
map-name
Displays the PFC and ETS parameters configured in the specified
map.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use the show qos dcb-map command to display the enhanced transmission selection
(ETS) and priority-based flow control (PFC) parameters used to configure server-facing
Ethernet ports. S5000 Ethernet ports are DCBx-enabled by default.
The following table describes the show qos dcb-map output shown in the example below.
Field Description
State Complete: All mandatory DCB parameters are correctly configured.
In progress: The DCB map configuration is not complete. Some
mandatory parameters are not configured.
PFC Mode PFC configuration in DCB map: On (enabled) or Off.
PG Priority group configured in the DCB map.
TSA Transmission scheduling algorithm used by the priority group:
Enhanced Transmission Selection (ETS).
BW Percentage of bandwidth allocated to the priority group.
PFC PFC setting for the priority group: On (enabled) or Off.
Priorities 802.1p priorities configured in the priority group.
Example
FTOS# show qos dcb-map dcbmap2
State :Complete
PfcMode:ON
--------------------
402