Command Line Reference Guide

Command Modes CONFIGURATION
INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
A DCB map is a template used to configure DCB parameters and apply them on converged
Ethernet interfaces. DCB parameters include priority-based flow control (PFC) and enhanced
traffic selection (ETS).
To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map command.
Use the dcb-map command to create a DCB map to specify PFC and ETS settings and apply it
on Ethernet ports. After you apply a DCB map to an interface, the PFC and ETS settings in the
map are applied when the Ethernet port is enabled. DCBx is enabled on Ethernet ports by
default.
The dcb-map command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the no dcb-map map-name command in
Interface configuration mode.
Related
Commands
show qos dcb-map– displays the dcb-map profiles configured on the system.
dcb-map stack-unit all stack-ports all– applies a DCB map on all ports of a switch stack.
dcb-map stack-unit all stack-ports all
Apply the specified DCB map on all ports of the switch stack.
S5000
Syntax
dcb-map stack-unit all stack-ports all dcb-map-name
To remove the PFC and ETS settings in a DCB map from all stack units, use the no dcb-map
stack-unit all stack-ports all
command.
Parameters
dcb-map-name Enter the name of the DCB map.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The dcb-map stack-unit all stack-ports all command overwrites any
previous DCB maps applied to stack ports.
Related
Commands
dcb-map – creates a DCB map to configure PFC and ETS parameters and applies the PFC and
ETS settings on Ethernet ports.
393