Command Line Reference Guide

stack-unit all
stack-ports all
Enter the keyword stack-unit followed by all stack-ports
all to clear the counters on all interfaces.
Defaults none
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
dcb enable
Enable data center bridging.
S5000
Syntax
dcb enable
To disable DCB, use the no dcb-enable command.
Defaults Enabled
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
By default, DCB is enabled and link-level flow control is disabled on all S5000 interfaces.
To disable DCB, enter the no dcb enable command.
Related
Commands
dcb-map– creates a DCB map to configure PFC and ETS parameters and apply the PFC and
ETS settings on Ethernet ports.
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on Ethernet ports
that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
S5000
Syntax
dcb-map map-name
Parameters
map-name
Enter a DCB map name. The maximum number of alphanumeric
characters is 32.
Defaults None. There are no pre-configured PFC and ETS settings on S5000 Ethernet interfaces.
392