Command Line Reference Guide

Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To disable TLV transmission, use the no form of the command; for example, no advertise
dcbx-appln-tlv iscsi.
advertise dcbx-tlv
On a DCBx port with a manual role, configure the PFC and ETS TLVs advertised to DCBx peers.
S5000
Syntax
advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-
reco | pfc] [ets-conf | ets-reco | pfc]
To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.
Parameters
{ets-conf | ets-
reco | pfc}
Enter the PFC and ETS TLVs advertised, where:
• ets-conf: enables the advertisement of ETS configuration
TLVs.
• ets-reco: enables the advertisement of ETS recommend
TLVs.
• pfc: enables the advertisement of PFC TLVs.
Defaults All PFC and ETS TLVs are advertised.
Command Modes PROTOCOL LLDP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You can configure the transmission of more than one TLV type at a time; for example:
advertise dcbx-tlv ets-conf ets-reco.
You can enable ETS recommend TLVs (ets-reco) only if you enable ETS configuration TLVs
(
ets-conf). To disable TLV transmission, use the no form of the command; for example, no
advertise dcbx-tlv pfc ets-reco.
DCBx requires that you enable LLDP to advertise DCBx TLVs to peers.
Configure DCBx operation at the INTERFACE level on a switch or globally on the switch. To
verify the DCBx configuration on a port, use the show interface dcbx detail
command.
390