Command Line Reference Guide

• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
• L2PT (l2pt): 0
• MAC ACLs (ipmacacl): 0
• ECFMACL (ecfmacl): 0
• VMAN QoS (vman-qos): 0
• VMAN Dual QoS (vman-dual-qos): 0
• FCoE ACL (fcoeacl): 2
• iSCSI Opt ACL (iscsioptacl): 0
l2acl number
ipv4acl number
ipv6acl
number ipv4qos
number l2qos
number l2pt
number ipmacacl
number ecfmacl
number {vman-
qos number |
vman-dual-qos
number } [fcoeacl
number ][iscsiacl
number ]
Enter the number fo FP blocks to be allocated to each CAM region.
Separate each keyword and number with a blank space. the total
allocated CAM space must equal 13.
The ipv6acl and vman–dual–qos allocations must be entered as a
factor of 2 (2, 4, 6, 8, or 10). All other CAM regions can use either even
or odd numbered numbers.
The range of memory blocks that you can allocate to each CAM
region is 0 to 10.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Clarified block information for the S5000.
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy run
start) then reload the system for the new settings to take effect.
The total amount of CAM space allowed is 16 FP Blocks. System flow requires three blocks;
these blocks cannot be reallocated. Therefore, the total number of allocated blocks for all CAM
regions must be 13.
cam-acl-egress (Configuration)
Select the FP groups for CAM access control lists for Layer 2, IPv4, and IPv6 ACLs.
S5000
Syntax
cam-acl-egress {default | l2acl number ipv4acl number ipv6acl
number}
378