Command Line Reference Guide
11
Bare Metal Provisioning (BMP)
Bare metal provisioning (BMP) version 2.0 is supported on the S5000 switch.
In a data center network, BMP automates the configuration and updating of switches, ensuring standard configurations
across the installed devices.
You can configure auto-configuration on a single switch or on multiple switches. BMP allows you to set up a stack with
a minimum of effort, but is also useful for quick configuration of a single switch.
For additional information about BMP in Auto-Configuration mode, refer to the
Open Automation Guide
.
BMP 2.0 eases configuration by providing the following key features:
• Boot images and running configurations are specified in a DHCP server.
• Files are automatically downloaded from a file server and applied by the switch
• Switch access is allowed through all ports (management and user ports) with or without DHCP-based dynamic
IP address configuration of a switch.
• Booting up in Layer 3 mode with interfaces already in No Shutdown mode and only enabling some basic
protocols to protect the system and the network
reload type
BMP 2.0 AutoCconfiguration mode: Configure a switch to reload in Normal mode or as a DHCP client with all ports
configured for Layer 3 traffic.
S5000
Syntax
reload-type {normal-reload | jump-start [config-download
{enable | disable}] [dhcp-timeout minutes]}
Parameters
normal-reload The switch reloads in Normal mode using the FTOS image and startup
configuration file stored in the local flash
jump-start The switch reloads in Jumpstart mode as a DHCP client.
config-download
{enable | disable}
(Optional) Configure whether the switch boots up using the
configuration file downloaded from the DHCP/file servers (enable) OR
if the downloaded file will be discarded and the startup configuration
file stored in the local flash will be used (disable).
dhcp-timeout
minutes
(Optional) Configure the DHCP timeout (in minutes) after which the
Jumpstart reload stops. The range is 1 to 50. The default is Infinite
number of retries.
Defaults A switch running BMP 2.0 reloads in Jumpstart mode as a DHCP client with all ports
configured for Layer 3 traffic.
373