Command Line Reference Guide

Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes the sho ip bgp ipv4 multicast summary command
shown in the Example below.
BGP router
identifier
Displays the local router ID and the AS number.
BGP table version Displays the BGP table version and the main routing table version.
network entries Displays the number of network entries, route paths, and the amount
of memory used to process those entries.
BGP path
attribute entries
Displays the number of BGP path attributes and the amount of
memory used to process them.
BGP AS-PATH
entries
Displays the number of BGP AS_PATH attributes processed and the
amount of memory used to process them.
BGP community
entries
Displays the number of BGP COMMUNITY attributes processed and
the amount of memory used to process them. The show ip bgp
community
command provides more details on the COMMUNITY
attributes.
Dampening
enabled
Displayed only when you enable dampening. Displays the number of
paths designated as history, dampened, or penalized.
Neighbor Displays the BGP neighbor address.
AS Displays the AS number of the neighbor.
MsgRcvd Displays the number of BGP messages that neighbor received.
MsgSent Displays the number of BGP messages that neighbor sent.
TblVer Displays the version of the BGP table that was sent to that neighbor.
InQ Displays the number of messages from that neighbor waiting to be
processed.
OutQ Displays the number of messages waiting to be sent to that neighbor.
If a number appears in parentheses, the number represents the
number of messages waiting to be sent to the peer group.
Up/Down
Displays the amount of time (in hours:minutes:seconds) that the
neighbor is in the Established stage. If the neighbor has never moved
into the Established stage, the word never is displayed.
State/Pfxrcd
If the neighbor is in Established stage, the number of network prefixes
received.
If a maximum limit was configured with the neighbor maximum-
prefix command, (prfxd) appears in this column.
If the neighbor is not in Established stage, the current stage is
displayed (Idle, Connect, Active, OpenSent, OpenConfirm). When the
361