Command Line Reference Guide

network
Specify the networks for the BGP process and enter them in the BGP routing table.
S5000
Syntax
network ip-address mask [route-map map-name]
To remove a network, use the no network ip-address mask [route-map map-
name] command.
Parameters
ip-address
Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format (for
example, /24).
The mask appears in command outputs in dotted decimal format
(A.B.C.D).
route-map
map-
name
(OPTIONAL) Enter the keyword route-map followed by the name of
an established route map.
Only the following ROUTE-MAP mode commands are supported:
match ip address
set community
set local-preference
set metric
set next-hop
set origin
set weight
If the route map is not configured, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
FTOS software resolves the network address configured by the network command with the
routes in the main routing table to ensure that the networks are reachable using non-BGP
routes and non-default routes.
Related
Commands
redistribute – redistributes routes into the BGP.
349