Command Line Reference Guide

If the Route map is not configured, the default is deny (to drop all
routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of
the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in
the Route map used in this command. If you identify a peer by IP address, the Route map
overwrites either the inbound or outbound policies on that peer.
neighbor route-reflector-client
Configure a neighbor as a member of a route reflector cluster.
S5000
Syntax
neighbor {ip-address | peer-group-name} route-reflector-client
To indicate that the neighbor is not a route reflector client or to delete a route reflector
configuration, use the no neighbor ip-address | peer-group-name route-
reflector-client
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
All routers in the peer group receive routes from a route reflector.
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The first time you enter this command, it configures the neighbor as a route reflector and
members of the route-reflector cluster. If you configure a route reflector, internal BGP (IBGP)
speakers do not need to be fully meshed.
When you disable all clients of a route reflector, the neighbor is no longer a route reflector.
348