Command Line Reference Guide

Field Description
Network Displays the network ID to which the route is flapping.
From Displays the IP address of the neighbor advertising the flapping route.
Flaps Displays the number of times the route flapped.
Duration Displays the hours:minutes:seconds since the route first flapped.
Reuse Displays the hours:minutes:seconds until the flapped route is
available.
Path Lists all the ASs the flapping route passed through to reach the
destination network.
Example
FTOS>show ip bgp flap
BGP table version is 210851, local router ID is 63.114.8.2
Status codes: s suppressed, d damped, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Flaps Duration Reuse
Path
FTOS>
show ip bgp inconsistent-as
View routes with inconsistent originating autonomous system (AS) numbers; that is, prefixes that are announced from
the same neighbor AS but with a different AS-Path.
S5000
Syntax
show ip bgp [ipv4 unicast] inconsistent-as
Command Modes
EXEC
EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes the show ip bgp inconsistent-as command shown in the
Example below.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is listed in
this column, then local routes exist in the routing table.
319