Command Line Reference Guide

Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight.
Path Lists all the ASs the route passed through to reach the destination
network.
Example
FTOS#show ip bgp community-list pass
BGP table version is 0, local router ID is 10.101.15.13
Status codes: s suppressed, d damped, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
FTOS#
show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
S5000
Syntax
show ip bgp [ipv4 unicast] dampened-paths
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes the show ip bgp damp command shown in the Example below.
Field Description
Network Displays the network ID to which the route is dampened.
From Displays the IP address of the neighbor advertising the dampened
route.
Reuse Displays the hour:minutes:seconds until the dampened route is
available.
Path Lists all the ASs the dampened route passed through to reach the
destination network.
Example
FTOS>show ip bgp damp
BGP table version is 210708, local router ID is 63.114.8.2
Status codes: s suppressed, d damped, h history, * valid, >
313