Command Line Reference Guide

neighbor send-community
Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that all routes with
that attribute belong to the same community grouping.
S5000
Syntax
neighbor {ip-address | peer-group-name} send-community
To disable sending a COMMUNITY attribute, use the no neighbor {ip-address |
peer-group-name} send-community command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to send a COMMUNITY attribute to
all routers within the peer group.
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command Modes ROUTER BGP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To configure a COMMUNITY attribute, use the set community command in ROUTE-MAP
mode.
neighbor shutdown
Disable a BGP neighbor or peer group.
S5000
Syntax
neighbor {ip-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the neighbor {ip-address |
peer-group-name} no shutdown command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to disable or enable all routers
within the peer group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes ROUTER BGP
Command History
Version 9.0(1.3) Introduced on the S5000.
298