Command Line Reference Guide

Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to apply the filter to all routers in the
peer group.
restart-time
seconds
Enter the keyword restart-time followed by the maximum
number of seconds needed to restart and bring-up all the peers. The
range is 1 to 3600 seconds. The default is 120 seconds.
stale-path-time
seconds
Enter the keyword stale-path-time followed by the maximum
number of seconds to wait before restarting a peer’s stale paths. The
default is
360 seconds.
role receiver-only Enter the keyword role receiver-only to designate the local
router to support graceful restart as a receiver only.
Defaults as above
Command Modes ROUTER BGP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This feature advertises to BGP neighbors through a capability advertisement. In Receiver Only
mode, BGP saves the advertised routes of peers that support this capability when they restart.
neighbor local-as
Configure Internal BGP (IBGP) routers to accept external routes from neighbors with a local AS number in the AS
number path.
S5000
Syntax
neighbor {ip-address | peer-group-name} local-as as-number [no-
prepend]
To return to the default value, use the no neighbor {ip-address | peer-group-
name} local-as command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to set the advertisement interval for
all routers in the peer group.
as-number Enter the AS number to reset all neighbors belonging to that AS. The
range is 0 to 65535 (2-byte), 1 to 4294967295 (4-byte) or 0.1 to
65535.65535 (dotted format).
no prepend Specifies that local AS values do not prepend to announcements from
the neighbor.
289