Command Line Reference Guide

debug ip bgp soft-reconfiguration
Enable soft-reconfiguration debug.
S5000
Syntax
debug ip bgp {ip-address | peer-group-name} soft-
reconfiguration
To disable, use the no debug ip bgp {ip-address | peer-group-name}
soft-reconfiguration command.
Parameters
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name
(OPTIONAL) Enter the name of the peer group to disable or enable all
routers within the peer group..
Defaults Disabled
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging. If no neighbor is
specified, debug turns on for all neighbors.
debug ip bgp updates
Allows you to view information about BGP updates.
S5000
Syntax
debug ip bgp updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] updates [in | out] command.
Parameters
in (OPTIONAL) Enter the keyword in to view only BGP updates
received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP updates sent to
neighbors.
prefix-list
prefix-
list-name
(OPTIONAL) Enter the keyword prefix-list followed by the
name of an established prefix list. If the prefix list is not configured,
the default is permit (to allow all routes).
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
278