Command Line Reference Guide

set origin
Configure a filter to manipulate the BGP ORIGIN attribute.
S5000
Syntax
set origin {igp | egp | incomplete}
Parameters
egp Enter the keyword egp to set routes originating from outside the local
AS.
igp Enter the keyword igp to set routes originating within the same AS.
incomplete Enter the keyword incomplete to set routes with incomplete
routing information.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 9.0(1.3) Introduced on the S5000.
set tag
Configure a filter to specify a tag for redistributed routes.
S5000
Syntax
set tag tag-value
Parameters
tag-value Enter a number as the tag. The range is zero (0) to 4294967295.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
set automatic-tag – computes the tag value of the route.
set level – specifies the OSPF area for route redistribution.
set metric – specifies the metric value assigned to redistributed routes.
set metric-type – specifies the route type assigned to redistributed routes.
241