Command Line Reference Guide

external Enter the keyword external to assign the IS-IS external metric.
type-1 Enter the keyword type-1 to assign the OSPF Type 1 metric.
type-2 Enter the keyword type-2 to assign the OSPF Type 2 metric.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
set automatic-tag – computes the tag value of the route.
set level – specifies the OSPF area for route redistribution.
set metric – specifies the metric value assigned to redistributed routes.
set tag – specifies the tag assigned to redistributed routes.
set next-hop
Configure a filter to specify an IP address as the next hop.
S5000
Syntax
set next-hop ip-address
Parameters
ip-address
Specify an IP address in dotted decimal format.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If you configure the set next-hop command, its configuration takes precedence over the
neighbor next-hop-self command in the ROUTER BGP mode.
If you configure the set next-hop command with the interface’s IP address (either
Loopback or physical), the software declares the route unreachable.
Related
Commands
match ip next-hop – redistributes routes that match the next-hop IP address.
neighbor next-hop-self – configures the routers as the next hop for a BGP neighbor.
240