Command Line Reference Guide

Parameters
external [type-1|
type-2]
Enter the keyword external and then enter either type-1 or type-2
to match only on OSPF Type 1 routes or OSPF Type 2 routes.
internal Enter the keyword internal to match only on routes generated
within OSPF areas.
level-1 Enter the keyword level-1 to match IS-IS Level 1 routes.
level-2 Enter the keyword level-2 to match IS-IS Level 2 routes.
local Enter the keyword local to match only on routes generated within
the switch.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
match interface – redistributes routes that match the next-hop interface.
match ip address – redistributes routes that match an IP address.
match ip next-hop – redistributes routes that match the next-hop IP address.
match ip route-source – redistributes routes that match routes advertised by other routers.
match metric – redistributes routes that match a specific metric.
match tag – redistributes routes that match a specific tag.
match tag
Configure a filter to redistribute only routes that match a specified tag value.
S5000
Syntax
match tag tag-value
Parameters
tag-value Enter a value as the tag on which to match. The range is zero (0) to
4294967295.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
match interface – redistributes routes that match the next-hop interface.
match ip address – redistributes routes that match an IP address.
match ip next-hop – redistributes routes that match the next-hop IP address.
233