Command Line Reference Guide

match community
Configure a filter to match routes that have a certain COMMUNITY attribute in their BGP path.
S5000
Syntax
match community community-list-name [exact]
Parameters
community-list-
name
Enter the name of a configured community list.
exact (OPTIONAL) Enter the keywords exact to process only those routes
with this community list name.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
ip community-list – configures an Community Access list.
set community – specifies a COMMUNITY attribute.
neighbor send-community – sends COMMUNITY attribute to peer or peer group.
match interface
Configure a filter to match routes whose next hop is on the interface specified.
S5000
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE and then enter the slot/port information.
• For the loopback interface, enter the keyword loopback
and then enter a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword port-
channel and then enter a number. The range is 1 to 128.
• For a VLAN, enter the keyword vlan and then enter a
number from 1 to 4094.
229