Command Line Reference Guide

Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
FTOS supports one ingress and one egress MAC ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed specifications on
entries allowed per ACL, refer to your switch documentation.
Example
FTOS(conf)#mac-access-list access-list standard TestMAC
FTOS(config-std-macl)#?
deny Specify packets to reject
description List description
exit Exit from access-list configuration mode
no Negate a command or set its defaults
permit Specify packets to forward
remark Specify access-list entry remark
seq Sequence numbers
show Show Standard ACL configuration
permit
Configure a filter to forward packets from a specific source MAC address.
S5000
Syntax
permit {any | mac-source-address [mac-source-address-mask]}
[count [byte]]] [monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s sequence
number.
• Use the no permit {any | mac-source-address mac-source-
address-mask} command.
Parameters
any Enter the keyword any to forward all packets received with a MAC
address.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
(OPTIONAL) Specify which bits in the MAC address must match. If no
mask is specified, a mask of 00:00:00:00:00:00 is applied (in other
words, the filter allows only MAC addresses that match).
count (OPTIONAL) Enter the keyword count to count packets processed
by the filter.
213