Command Line Reference Guide

Total Ports: 1024
Related
Commands
ip access-list extended – creates an extended ACL.
permit – assigns a permit filter for IP packets.
permit udp – assigns a permit filter for UDP packets.
permit udp
Configure a filter to pass UDP packets meeting the filter criteria.
S5000
Syntax
permit udp {source mask | any | host ip-address} [operator port
[port]] {destination mask | any | host ip-address} [dscp]
[operator port [port]] [count [byte]] [order] [monitor]
[fragments]
To remove this filter, you have two choices:
Use the no seq sequence-number command if you know the filter’s sequence
number.
Use the no permit udp {source mask | any | host ip-address}
{destination mask | any | host ip-address command.
Parameters
source
Enter the IP address of the network or host from which the packets
were sent.
mask
Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or non-
contiguous.
any Enter the keyword any to specify that all routes are subject to the
filter.
host
ip-address
Enter the keyword host and then enter the IP address to specify a
host IP address.
dscp Enter the keyword dscp to deny a packet based on the DSCP value.
The range is 0 to 63.
operator
(OPTIONAL) Enter one of the following logical operand:
eq = equal to
neq = not equal to
gt = greater than
lt = less than
range = inclusive range of ports (you must specify two ports
for the
port parameter)
202