Command Line Reference Guide

source
Enter the IP address of the network or host from which the packets
were sent.
mask
Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or
noncontiguous.
any Enter the keyword any to specify that all routes are subject to the
filter.
host
ip-address
Enter the keyword host and then enter the IP address to specify a
host IP address.
destination
Enter the IP address of the network or host to which the packets are
sent.
count (OPTIONAL) Enter the keyword count to count packets that the filter
processes.
byte (OPTIONAL) Enter the keyword byte to count bytes that the filter
processes.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP
values.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for
the ACL entry. The range is 0 to 254 (where 0 is the highest priority
and 254 is the lowest; lower-order numbers have a higher priority). If
you do not use the keyword order, the ACLs have the lowest order
by default (255).
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface. For more
information, refer to the “Flow-based Monitoring” section in the Port
Monitoring chapter of the
FTOS Configuration Guide
.
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. For more
information, refer to the Quality of Service chapter of the
FTOS Configuration Guide
.
When you use the log option, the CP processor logs detail the packets that match. Depending
on how many packets match the log entry and at what rate, the CP may become busy as it has
to log these packets’ details.
The monitor option is relevant in the context of flow-based monitoring only. For more
information, refer to the Port Monitoring chapter.
The S5000 cannot count both packets and bytes, when you enter the count byte options, only
bytes are incremented.
191