Command Line Reference Guide
resequence prefix-list ipv4
Re-assign sequence numbers to entries of an existing prefix list.
S5000
Syntax
resequence prefix-list ipv4 {prefix-list-name StartingSeqNum
Step-to-increment}
Parameters
prefix-list-name
Enter the name of the configured prefix list, up to 140 characters long.
StartingSeqNum
Enter the starting sequence number to resequence. The range is 0 to
65535.
Step-to-
Increment
Enter the step to increment the sequence number. The range is 1 to
65535.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you have exhausted all the sequence numbers, this feature permits re-assigning a new
sequence number to entries of an existing prefix list.
Related
Commands
resequence access-list – resequences an access-list.
seq
Assign a sequence number to a deny or permit filter in an IP access list while creating the filter.
S5000
Syntax seq
sequence-number
{deny | permit} {
source
[
mask
] | any | host
ip-address
}} [count [byte] ]
[dscp
value
] [order] [monitor] [fragments]
Parameters
sequence-
number
Enter a number from 0 to 4294967290.The range is 0 to 65534.
deny Enter the keyword deny to configure a filter to drop packets meeting
this condition.
permit Enter the keyword permit to configure a filter to forward packets
meeting this criteria.
188