Command Line Reference Guide

in Enter the keyword in to apply the ACL to incoming traffic.
implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the
default action of the ACL from implicit-deny to implicit-permit (that is,
if the traffic does not match the filters in the ACL, the traffic is
permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the ID numbers of
the VLANs.
Defaults Not enabled.
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You can assign one ACL (standard or extended ACL) to an interface.
NOTE: This command does not support S5000 Loopback interfaces.
When you apply an ACL that filters IGMP traffic, all IGMP traffic is redirected to the CPUs and
soft-forwarded, if required, in the following scenarios:
• on a Layer 2 interface - if a Layer 3 ACL is applied to the interface
• on a Layer 3 port or on a Layer 2/Layer 3 port
Related
Commands
ip access-list standard – configures a standard ACL.
ip access-list extended – configures an extended ACL.
show ip access-lists
Display all of the IP ACLs configured in the system, whether or not they are applied to an interface, and the count of
matches/mismatches against each ACL entry displayed.
S5000
Syntax
show ip access-lists [access-list-name] [interface type slot/
port] [in | out]
Parameters
access-list-name Enter the name of a configured MAC ACL, up to 140 characters.
interface type
slot/port
Enter the interface keyword followed by the interface type and
slot/port or number information. Valid slot numbers are 0-11. The valid
port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
181